How to create your fountain

After deciding where your fountain will go, you will need to excavate a hole in which to install the liner and pre liner.

The excavation should be deep enough for the pre liner and liner and be just deep enough to cover the pump, the average will be 6 inches deep. Do remember this is for a fountain, not a pond

The base of the excavation should be perfectly level, so that when the pump is installed it sits level.

Once the excavation is finished and lined you  can then install the pump and nozzle, then fill the pool with water.

Lay slabs around the edge of the pool on a bed of mortar (This is a fountain, not a pond)

Connect the pump in via an RCD protected supply, sit back and enjoy.

Please note: The above information is for guidance only and is for a fountain pool, not a pond.